QC Set Report in iQC Print not displaying trial measurement data

Your QC Set Report in iQC Print is only showing header and standards information but "NOT" displaying the trial measurement data (or results) in the report. This is most likely due to the Tag settings are set to "system defaults". The Tag settings need to be set to "Print" specific tag formatting. These settings are as follows:

In the System Settings and under the Tag Format tab:

Trial Label formats are determined by: PackagingBAT.fmt
Standard Label formats are determined by: PackagingSTD.fmt

Job Default (in your Default e-job settings file or Default_1024.st5 file):

Trial Label formats are determined by: PackagingBAT.fmt
Standard Label formats are determined by: PackagingSTD.fmt

*NOTE: We recommend these settings be consistent in any Job Templates that may be using QC Sets.