Restoring VeriColor's Factory Presets

Restoring VeriColor's Factory Presets

Restoring VeriColor's Factory Presets

 

VeriColor's "Factory Presets" are restored by pressing and holding (for approximately two seconds) the hub's 'Up', 'Down', and 'Enable' buttons simultaneously. The output LED will illuminate amber and then red. At this point, the factory settings are restored. The reset can be aborted by releasing the buttons before the LED turns red. Always reset the hub (using the 'Reset Switch') after restoring factory presets. Restoring the factory presets clears the following data -

Performing a factory preset does not clear the calibration data or the hub and sensor head serial numbers.

 

¿Tiene preguntas? ¿Necesita un presupuesto? Contáctenos(888) 800-9580