Resetting an X-Rite DTP41
There are two reset procedures for X-Rite's DTP41; no software is required.POWER UP RESET
This procedure resets the instrument to it's power-up defaults as last set by either the factory, or a third party package of software.
- Plug in the instrument.
- Press and hold the black measure button until it glows RED.
- Release the button.
- Press the button again (This must be done within ten seconds of step 3, or the instrument will return to the ready to measure mode, without resetting).
FULL FACTORY RESET - This will reset the instrument to the default settings for both measurement modes and communications.
- Unplug the instrument from power.
- Press and hold the black measure button.
- While holding the button, plug the instrument back in. The light will turn RED.
- Release the button. The light will turn green. The instrument is now returned to factory default settings.
Alternative Option. The Toolcrib software also allows the flexiblity to perform a reset as well which will return the device to a Factory Default status. Once the instrument is connected to the software simply click the Reset Option.
